[TowerTalk] Crimp Tool For LMR 240 / 400

[K8RI on TT]

On 9/27/2011 12:47 AM, Tony wrote:
> On 9/27/2011 12:29 AM, Jim Lux wrote:
>
> what's reasonable?  $40 or $400
>
> Hi Jim,
>
> Under $100..

Try Davis, RF Parts,  Try the Wireman, Just try most any of those 
selling coax and look in the accessories sections.   There's been one 
advertised in QST for nearly every month over the past couple of years,

I have two different 3, two of which cover from RG-58/8X/6U/59/8U/LMR400 
and others of the same size range.  The third is for LMR-600.  None of 
them cost over $100.  The two for the smaller sizes each use 
interchangeable dies to cover a wide range of sizes.

73

Roger (K8RI)
>
> Tony
>
>
>> On 9/26/11 9:24 PM, Tony wrote:
>>> All,
>>>
>>> I'm looking for a reasonably priced crimping tool that can handle both
>>> LMR 240 and LMR400 connectors.
>>>
>> what's reasonable?  $40 or $400
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>> __________ Information from ESET NOD32 Antivirus, version of virus signature database 6496 (20110926) __________
>>
>> The message was checked by ESET NOD32 Antivirus.
>>
>> http://www.eset.com
>>
>>
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>