[TowerTalk] Taper changes using EZNEC+

[john at kk9a.com]

Thanks to all that responded to my EZNEC modeling question.  After trying
other modeling software and doing some research I decided to go with W6RMK's
suggestion of using the W6QHS algorithm to adjust my model.  Thankfully N2IC
mentioned that there was a spreadsheet available for the calculations which
will mike this task much easier.

73,
John  KK9A  aka P40A


-------- Original Message --------
Subject: Taper changes using EZNEC+
Date: 2012-05-11 09:29
 From: john at kk9a.com
To: <towertalk at contesting.com>

I would like to change tubing diameters on an antenna that I have
previously designed.  Is there a way do this and maintain the same
element resonate frequency using EZNEC+?  I tried "Show Stepped Dia
Correction" thinking it would be easy see how much longer or shorter the
new element is, however there seems to be no way to make the new and old
correction diameters identical.  It would be nice if I could set a
standard taper correction size. Any suggestions?

John KK9A