[TowerTalk] Recabling info needed for US Tower HDX-589

[Bob K6UJ]

Bill,
Sorry to hear about the cable failure. 
I have the US Tower  HDX-589MDPL and had mine recabled 6 years ago by Skip, KJ6Y.   His business is tower installation and repair.  
He has done a lot of work on towers like ours.  He would be a good contact for information and could recable it for you too if you wish.

Heres his contact info:

Harold Bolnick
Communications Service Co.
22712 Califa St.
Woodland hills, CA  91367
(818) 887-3569
email:  kj6y at aol.com


73,
Bob
K6UJ







On May 22, 2012, at 1:04 PM, Bill Erickson wrote:

> I have had the misfortune of a cable breaking on my US Tower HDX-589. The
> fall from 89 feet to 23 feet didn't hurt it, but the stop at the bottom was
> a killer! I am in the process of fabricating 5 new pulley brackets and
> replacing some of the 2 inch by 1 inch "U" channels that were bent or whose
> welds to the upright tubes were broken.  No problem there. I have been
> unable to get any help whatsoever from US Tower. My cables were damaged in
> the fall/stop so I do not want to trust measurements on them to have new
> cables made. Does any one have the dimensions of the various cables, and a
> cable routing diagram for this tower? Any help would be greatly
> appreciated. I have already missed 2 "Must Have" DxPeditions. Thanks and
> 73,   Bill    N6MXU
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk