[TowerTalk] Rohn 45g

[Marshall Stewart]

The Rohn 45G sections I have are not tapered on either end.  The vertical
tubes are the same diameter from top to bottom.  At the bottom of each
section, larger diameter short pieces (with an ID slightly larger than the
OD of the vertical tubes) are welded on to allow the bottom of the section
to fit onto the top of the section below.  Each joint has 6 bolts, 2 per
leg.  Each section weighs about 70 pounds. 

73,
Marsh, KA5M

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Larry
Melby
Sent: Thursday, October 25, 2012 2:47 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Rohn 45g

Rohn 45g leg sections are tapered where one section mates to another, Rohn
45gsr 
(self supporting model) uses flanges that bolt together.

73
Larry KA5TXL




________________________________
From: les <lkemble at charter.net>
To: towertalk at contesting.com
Sent: Thu, October 25, 2012 1:34:30 PM
Subject: [TowerTalk] Rohn 45g

How do I tell what type of Rohn 45 tower sections I have?
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk