[TowerTalk] Fwd: Heights pre-1995 Aluminum Tower
Hans Hammarquist
hanslg at aol.com
Sat Sep 29 09:43:24 EDT 2012
I am using a mix of Heights and Universal. They have about the same dimensions and (claim) material. You can use that for wind data and, to a limited extent, load allowance.
With a "light squeeze" they fit together. I was told by the engineer from Universal that the old Heights tower were manufactured without templates (take it from where it comes) and therefor it is important that you match up the sections correct (and carefully). The Universal sections fit irregardless when they were purchased.
Another thing, make sure to check the welding of the cross members. I have to spend some time/money to get them redone. Several had cracks in them to the point that some even were lose.
Good luck. I was successful in my assembly even if it took some time (and nerves ;-).
Hans - N2JFS
-----Original Message-----
From: jeryb77 <jeryb77 at hotmail.com>
To: towertalk <towertalk at contesting.com>
Sent: Sat, Sep 29, 2012 12:57 am
Subject: [TowerTalk] Heights pre-1995 Aluminum Tower
Hello,
I am trying to locate any information for pre-1995 Heights Aluminum Free
Standing Towers.
Catalog or Datasheet scans would be appreciated.
Thank you,
Jerry
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list