[TowerTalk] Rohn TB3 questions
K7LXC at aol.com
K7LXC at aol.com
Tue Apr 16 17:36:31 EDT 2013
> Removed the 3 tightning bolts as they were rusty. If I get stainless to
replace I'm guessing they would gall. How abt the 'green' ones. The
higher grade bolts?
Any hardware the same size is fine. They are very beefy for the job
they're asked to do.
> Do the bearing get lubed? It spins freely now. I did clean they out as
there was a bit if grime in the race.
Do not lube the TB - it's designed to run dry. If you do put grease in
there, it'll just collect dirt and grit and decrease the service life of
the bearing.
A new TB will spin freely. A good used one will spin also but may be
rough due to wind hammering the ball bearings into the aluminum races.
Cheers,
Steve K7LXC
TOWER TECH
More information about the TowerTalk
mailing list