[TowerTalk] LMR-400/UF Type N Crimp Connector

[Jim Froemke]

The RFN1006-3i male N connector has a crimp center conductor. It's on the
rf.parts.com website. Be sure to use shrink wrap with the glue inside for
sealing the final connection.
http://www.rfparts.com/catalogsearch/result/?q=rfn1006-3i

73, Jim
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Jim
Rhodes
Sent: Sunday, August 4, 2013 8:34 AM
To: Jason Dugas
Cc: towertalk at contesting.com
Subject: Re: [TowerTalk] LMR-400/UF Type N Crimp Connector

therfc.com lists one. But I don't know if the center pin is crimp or solder.
Give them a call, they are helpful folks. Tech Support (301)
840-5477 or drop them an e-line- email address: rfc at therfc.com


On Sun, Aug 4, 2013 at 8:23 AM, Jason Dugas <kb5urq at hotmail.com> wrote:

> Does anyone know if there is a crimp Type N connector available for 
> LMR-400/UF (Ultra Flex)?I have seen some advertised as crimp but they 
> require soldering the center conductor. The reason I'm looking is that 
> I have a tower job where the ultraflex connectors need to be replaced 
> but am trying to avoid soldering up on the tower.Thanks,JasonKB5URQ 
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



--
Jim K0XU
jim at rhodesend.net
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk