[TowerTalk] Hose Clamps

[Grant Saviers]

This could be the result of "value engineering" of the hose clamps by 
MFJ, so you might consider buying new clamps from McMaster or others 
that are US made "all stainless".

I also found in assembling 3x TH7's and other antennas with hose clamped 
slitted tube sections that 2 or 3 tightening cycles are needed.  After 
some thermal cycles and a few days the stresses redistribute in the 
connection.  If you can create larger thermal cycles on purpose,  it 
helps - e.g. leave the antenna in the sun and then sprinkle with cold 
water.  Then retighten each clamp.  So far, this has worked with no 
loose elements after years of service.  The boom clamps can also benefit 
from this approach.  Retightening bolts after a few thermal cycles is a 
standard manufacturing process when fastening systems are near their 
stress limits.

The small diameter clamps are the most fragile, so have some spares.

Grant KZ1W


On 1/26/2013 10:05 PM, Jerry Gardner wrote:
> I'm putting together a TH-7DX and am having trouble with the hose clamps
> used to hold the telescoping sections of the elements together, especially
> the smaller diameter tubes.
>
> The instructions say to tighten the clamps until the two tubes will not
> slide in and out or rotate in each other. I find that if I tighten the
> clamps enough so that this is so, the clamps often break (the screw housing
> bends and will no longer hold the screw).
>
> Is there a way to tighten the clamps enough to secure the tubing without
> breaking them?
>
> 73, Jerry
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>