[TowerTalk] UST bolt Torque question
Rick Karlquist
richard at karlquist.com
Tue Jun 25 16:14:38 EDT 2013
Dick Green WC1M wrote:
> My approach to tightening nuts when no torque setting is specified is to
> pay
> close attention to the "feel". Screw the nut onto the bolt by hand until
I have been intuitively doing this for a long time on nearly
every bolt I tighten, including my HDX-5106
1 inch bolts. They especially have a very distinct increase in effort
since I greased them. If greased and no thread damage, they often won't
even go 1/4 turn with a wrench after reaching the hand tight
point.
Rick N6RK
More information about the TowerTalk
mailing list