[TowerTalk] Yaesu 450A Rotor Wiring Question

Mike Ryan mryan001 at tampabay.rr.com
Wed Nov 13 20:56:19 EST 2013

Thanks for the replies on this.
  The manual that I mistakenly downloaded was for a 450 XL rotor which is 
not the same as the 450 A.  The 450 A manual directions are quite clear. 
Thanks especially to TOM, W3RFG for clearing up the matter.  -Thanks again 
to all who replied.  - Mike

-----Original Message----- 
From: Mike Ryan
Sent: Wednesday, November 13, 2013 7:22 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Yaesu 450A Rotor Wiring Question

The instructions for the 450 rotator show a six pin plug for the
control box and a SEVEN pin round connector that attaches to the actual
motor drive unit. The instructions further say NOT to use pin #1 on the
round connector.  Does that mean that pin#1 on both the control box plug and
the round plug are not used?  Does this rotor then just use only 5 wires to
operate?  Am I missing something?  How do the control box plug and the round
connector wire? - Mike

TowerTalk mailing list
TowerTalk at contesting.com

More information about the TowerTalk mailing list