[TowerTalk] Rotor location
Rex Turvin
turvin2009 at yahoo.com
Tue Nov 26 14:44:01 EST 2013
I now have my Rohn 25 tower assembled awaiting my concrete to cure before erecting.
I am getting ready to mount my rotor. At the top of the Rohn 25 sections I am using A BPL25G thrust bearing assembly section which has the top plate approximately 18" above the 1st section of cross members. My plan is to place the rotor at the 2nd set of cross members on the top section.
Is this a good distance from the thrust bearing? If not, how much spacing do I need and why?
Thank you in advance for the advice. Wanting to make sure I do this as best as possible.
73 NR6M
ex: KF7NMD
Sincerely,
Rex Turvin
www.nr6m.com
More information about the TowerTalk
mailing list