[TowerTalk] TowerTalk] Rotator control program to slave two rotors??

[iain macdonnell - N6ML]

Yes, but there's no way (AFAIK) to link them together, such that one
can send all of the rotators for a stack to the same heading with a
single command.

73,

    ~iain / N6ML



On Thu, Sep 5, 2013 at 12:35 PM, David Jordan <wa3gin at comcast.net> wrote:
> Yes, works good.
>
> ----- Original Message ----- From: "Tom-W3FRG" <w3frg1 at gmail.com>
> To: <towertalk at contesting.com>
> Sent: Thursday, September 05, 2013 3:11 PM
> Subject: [TowerTalk] TowerTalk] Rotator control program to slave two
> rotors??
>
>
>
>> PstRotator is set up to handle multiple rotors.
>> Ref page 34 of the Operating manual.
>> To create multiple instances, just go to Help / Create Multiple Instances.
>> From there you can create/delete another 7 instances.
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk