[TowerTalk] Rohn 65G Flang Bolt Torque Specs

Grant Saviers grants2 at pacbell.net
Tue Sep 10 17:51:44 EDT 2013


Portland Bolt has the specs on their web site for tightening A325s. 
However, the question will remain if the connections are "slip 
critical".  If so then the torque is near to the web site value than 
otherwise, which are "snug tight plus 1/2 turn or similar".  Best to get 
the Rohn spec torque value particularly if you have flanged connections 
subject to the cyclical compression-tension loading of tower legs.

Grant KZ1W

On 9/10/2013 8:24 AM, Quinton Graham wrote:
> I bought a 5 yr old used 80 ft 65G (20ft Sections).  I bought new A-325 (HDG) bolts and nuts, but I cant seem to find torque specs on bolts for tower assembly. Rohn's $500 for assembly drawings seems a bit high just for torque specs.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



More information about the TowerTalk mailing list