[TowerTalk] Saddle clamp replacement

[Grant Saviers]

The DX Eng "V" saddle clamps are better than any muffler clamp since the 
casting will not splay out as the sides of a muffler clamp are prone to 
do under compression.  The "V" clamps are needed for pipe (IPS).  They 
make "U" clamps for most tubing sizes which have more clamping surface 
in contact with the tube.

Grant KZ1W


On 9/11/2013 2:14 AM, Doug Scribner wrote:
> DX Engineering
>
> http://www.dxengineering.com/search/brand/dx-engineering/product-line/dx-engineering-saddle-clamps?ibanner=DXHPRec0512001
>
> Doug - K1ZO
>
>
> Sent from my iPad
>
> On Sep 11, 2013, at 4:44 AM, Gerard Jendraszkiewicz <jend at uchicago.edu> wrote:
>
>> Hello,
>>
>> Any suggestions for a all stainless steel saddle clamp replacement ?
>>
>> Antenna is Force 12 5BA - Old clamps very rusty !
>>
>> 5/16" U-bolt, 2.25 inches (2 inch pipe) ?
>>
>> What say ?
>>
>> Thanks Jerry, KE9I
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>