[TowerTalk] HAM IV Height

[k6ye at q.com]

Jim,

I replaced a T2X Tailtwister with a Yaesu G-2800DXA and other than rewiring the plug on each end, I had to change nothing at all. The fit was perfect. I do use a thrust bearing to carry all of the weight of a Force-12 C-4XLD on a Hy-Gain HG-54HD crank-up tower.

Good luck in your endeavor.

Semper Fi,

Tommy - K6YE
DX IS and CW RULES


----- Original Message -----
From: James Setzler <jms_k1sd at verizon.net>
To: towertalk at contesting.com
Sent: Thu, 19 Sep 2013 11:35:16 -0400 (EDT)
Subject: [TowerTalk] HAM IV Height

Greetings,

 

I'm replacing a HAM IV with a Yaesu G-800GXA and concerned about the depth
of the mast into the rotor housing.

 

What is the dimension on the HAM IV from the mounting plate to the point
that the bottom of the mast rests?

 

    73 James K1SD

 

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk