[TowerTalk] Drill motor

[TexasRF at aol.com]

10 seconds on, 30 seconds off?
 
73/K5GW
 
 
 
 
In a message dated 2/20/2014 7:22:41 A.M. Pacific Standard Time,  
richard at karlquist.com writes:

300 RPM  is too fast for the winch, and the winch will
overheat.  If you slow  down the drill, then the little
fans inside do not provide adequate cooling  for the
drill and the drill overheats.  That is the  dilemma.

Rick N6RK

On 2/20/2014 6:55 AM, Mike Reublin NF4L  wrote:
> I ran across the DeWalt DWD460 drill. It draws 11 amps, and has  
continuously variable speeds in 2 ranges( 0 300 and 0 1300 RPM). Seems like  that 
would get away from the overheating problem in the worm-gear  winches.
>
> Anyone use one?
>
> 73, Mike NF4L
>  _______________________________________________
>
>
>
>  _______________________________________________
> TowerTalk mailing  list
> TowerTalk at contesting.com
>  http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk