[TowerTalk] yaesu G-2800DXA in a rohn 25 again

[Larry]

I have a KenPro KR2000. KenPro sold their rotator line to Yaesu and the 
KR2000 became the G2800DXA. I can put the KR2000 into a rotator shelf space 
of a 25G where there is no cross bracing. I don't think it will go in any 
other place. In the KR2000 you could take off the clamp pieces but I don't 
think even that would be enough.

I only had a pointed 25G top section to try. The only flat top section I 
have is on a tower and has a rotator in it so I couldn't try it. I don't 
recall trying to put the KR2000 in a 25G.

73, Larry  W6NWS

-----Original Message----- 
From: k7awbgoog at gmail.com
Sent: Wednesday, July 30, 2014 4:41 PM
To: towertalk at contesting.com
Subject: [TowerTalk] yaesu G-2800DXA in a rohn 25 again

I search the archives ,but could not tell if anyone has put this rotator 
into a Rohn 25 tower with a flat top section on top and did not have to cut 
out any side braces?  I was going to use a older, but refurbed Tailtwister, 
but since I will have two antennas on this rotator(Force 12 5BA and a 
17-element 2-meter M2,  I did not want to have  problems in the future.

Steve
K7AWB
Nine Mile Falls, WA
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk