[TowerTalk] ROHN TOWER BOLTS

[Scott Reed]

Here is a nice discussion of galling
http://www.estainlesssteel.com/gallingofstainless.html

On 5/9/2014 6:41 AM, john at kk9a.com wrote:
> The threads may have already had galling from tightening.  Once it starts
> it only gets worse.
>
> John KK9A
>
>
> To:	 towertalk <towertalk at contesting.com>
> Subject:	 Re: [TowerTalk] ROHN TOWER BOLTS
> From:	 Kim Elmore <cw_de_n5op at sbcglobal.net>
> Date:	 Thu, 8 May 2014 21:04:59 -0500
>
> That's contrary to my experience. I've had many SS nuts and bolts gall upon
> removal that did not gall upon application. However, it has not recurred
> since
> I started using anti-seize compound.
>
> Kim N5OP
>
> "People that make music together cannot be enemies, at least as long as the
> music lasts." -- Paul Hindemith
>
>> On May 8, 2014, at 20:44, Steve Maki <lists at oakcom.org> wrote:
>>
>> Even the most inadequate lubricant (WD40), when it comes to the subject
> of SS
>> galling, is by my calculations and experience, exactly 99.4% better than
> none
>> at all.
>>
>> I've never had SS hardware gall during the loosening process if it was
>> *truly* successfully tightened without any galling. And even WD40
>> accomplishes that.
>>
>> -Steve K8LX
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>

-- 
Scott Reed
Owner
NewWays Networking, LLC
Wireless Networking
Network Design, Installation and Administration
Mikrotik Advanced Certified
www.nwwnet.net
(765) 855-1060  (765) 439-4253  Toll-free (855) 231-6239