[TowerTalk] Phillistran

[Wayne Kline]

I am under the impression ,that Phillistran installation guid recommends appropriate steel/EHS
Guy wire at a safe tamper proof and ground fire height.
I have installed a number of both Phillistran and PollyRod towers,  guy / ground safety hight 
Plugged into the total guy equation .

Wayne. W3EA

Sent from my iPad

On May 24, 2014, at 11:56 PM, "Chuck Smallhouse" <w7cs at theriver.com> wrote:

> A story for those of you using Phillistran cable for guying a tower.
> 
> I was talking to a ham that lives in far N. CA, in area that is subject to wildfires.  A couple of years ago the area had a bad wildfire that moved in the direction of his QTH, in a somewhat rural area.  Even though the area around his home was quite well cleared, they couldn't save his workshop where most of his test equipment and ham equipment was located.
> 
> When he returned after a mandatory evacuation and surveyed the damage , he found that not only was his ham shack destroyed, but also his guyed tower had fallen over.   It turned out that he had guyed it using Phillistrand and that the fire had burned the guys through and which resulted in the catastrophic demise of his tower and beams.
> 
> I guess that the lesson to be learned is, to at least have the bottom sections of your  guys be of steel cable and not any type of flammable material, especially if you live in a wildfire prone area.
> 
> Chuck,  W7CS, with no Phillistrand guys .
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk