[TowerTalk] Adhesive lined heat shrink for connectors

[Mike Fahmie via TowerTalk]

A PL259 connector shell is ~3/4" diameter, Type N's are slightly larger.  Aim for at least 20mm tubing if your meaning to seal those.-Mike-WA6ZTY
 
      From: Bill Turner <dezrat at outlook.com>
 To: Towertalk <towertalk at contesting.com> 
 Sent: Wednesday, November 5, 2014 5:10 PM
 Subject: Re: [TowerTalk] Adhesive lined heat shrink for connectors
   
------------ ORIGINAL MESSAGE ------------(may be snipped)

On Mon, 03 Nov 2014 12:08:40 -0500, Mike wrote:

>
>Thanks for the suggestions Tom. I tried searching for 'flooded' heat 
>shrink but found I had better luck searching for 'lined' heat shrink.

REPLY:

On eBay, you could search for "adhesive heat shrink".  Currently there
are 1,575 listings. 

I just started using the 1/2 inch size myself for coax. So far, so
good. 

73, Bill W6WRT


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk