[TowerTalk] Rohn 25g foldover winch cable attachment

[Wayne Kline]

 Hi Dave
 
   went out in the snow to confirm .... I have two RG25 fold overs .. one up and on in storage  both sugar tubing tail pieces have  on hole drilled through them and the tabs for the  vertical  leg   positioning  tabs..... 
 
My Rohn   book   Drawing #  770034 R2    also depicts the through hole ... BUT  the  Photo  in the catalog shows it  going to the inside hole on the tab one side with two Crosby  clamps !!!!!
 
 
YMMV   Wayne W3EA
 
 
 
> Date: Fri, 28 Nov 2014 23:00:52 -0500
> From: davegr73 at gmail.com
> To: towertalk at contesting.com
> Subject: [TowerTalk] Rohn 25g foldover winch cable attachment
> 
> I'm in the process of setting up a rohn 25g foldover tower.  The tower is
> up but I'm not sure how to attach the winch cable.  I have downloaded a pdf
> of the manual but the end of the boom is different on my setup.  There are
> two holes that I could use.  If I attach to both of them it would interfere
> with folding over the tower.  If I use just one I'm concerned about the
> offset load.
> 
> Here is a picture of the end of the boom.
> https://lh4.googleusercontent.com/-UFTWN3yE0hI/VHjPnv4BUOI/AAAAAAAAAJM/XpAW8LpmCL4/w1278-h852-no/IMG_3146.jpg
> 
> 
> Dave
> N4PBC
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk