[TowerTalk] Zerk fitting for MA-40
Roger (K8RI) on TT
K8RI-on-TowerTalk at tm.net
Fri Apr 10 13:03:52 EDT 2015
All Zerks I have seen were either 1/8th inch, or 1/4 inch pipe thread,
or something that looked like a very coarse tapered strange pipe thread
on farm machinery, industry, and ham equipment over many years.
73
Roger (K8RI)
On 4/10/2015 12:26 PM, Kurt Cathcart. KR2C wrote:
> Good information everybody. And quick too! Thank you.
>
> One more question. Removing the remains of the Zeck fitting, would
> anybody know if this is tapped or pressed?
>
> -Kurt
> KR2C
>
>
> On 4/10/2015 11:59 AM, Kurt Cathcart. KR2C wrote:
>> I have a US Tower MA-40 with the rotator base. The last time I
>> greased the bearing, the Zerk fitting broke when I was removing the
>> grease gun. Does anybody have an idea of what I should replace it
>> with? I got crickets from US Tower.
>>
>> -Kurt
>> KR2C
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
More information about the TowerTalk
mailing list