[TowerTalk] Shrink Tubing

[Steve Maki]

Or add a few wraps of silicone tape on the smaller diameter before heat 
shrinking over it.

-Steve K8LX

On 12/19/2015 11:17 PM, n8de at thepoint.net wrote:

> Fill it with RTV silicone seal before you shrink it.

> Quoting Tony <dxdx at optonline.net>:

>> Is there shrink tubing that will reliably shrink by a 4:1 ratio? I
>> tried using some tubing I had on hand to cover several N-connector
>> jumpers with LMR-240 cable. It worked fine on the connector, but would
>> not shrink around the 1/4 inch cable.
>>
>> Any suggestions?