[TowerTalk] Mosley Antenna Question

Doug Scribner dscribner at twc.com
Tue Feb 17 07:20:30 EST 2015


Mike,

I have a TA-53M @ 43 feet on a small 2nd tower. I used a ferrite bead choke 
and RG-8X...about 60 feet. Of course I don't know what the pattern looks 
like, but the SWR curves come close to matching what the manual states.

Additionally I have a PRO-67B @ 68 feet fed through a Balun Designs 1:1 and 
DX Engineering 400 Max coax. Again no issues here either.

The usual disclaimer...Your Results May Vary...

Doug - K1ZO

----- Original Message ----- 
From: "Mike Ryan" <mryan001 at tampabay.rr.com>
To: <towertalk at contesting.com>
Sent: Tuesday, February 17, 2015 12:54 AM
Subject: [TowerTalk] Mosley Antenna Question


> Over the years I have heard stories of unexplained failures with Mosley 
> antennas which were equally unexplained as having to do with the selection 
> of certain coax cables. One recent incident was with a local here that had 
> trouble getting a PRO 67 to ‘cooperate’ only with the use of RG 213 cable. 
> Recalling this story, I have been asked to assist with the install of a 
> Mosley TA-53, 5 band beam on a 14ft boom.  NOTHING in the manual (which is 
> dated) suggests this but an on-line review of the TA-63 and a peek at a 
> manual found on-line also seem to suggest that the ‘recommended coax is 
> RG213”.  Any comments on the validity and reason for the use of JUST 
> RG-213 and not some other 50/52 ohm cable?  Thanks....  - Mike
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 



More information about the TowerTalk mailing list