[TowerTalk] Tuner SWR won't stay down

[K0DAN]

Has same behavior on dummy load?

Try getting rid of all coax switches, surge suppressors, anything in the RF 
path to antenna, then swap out jumper cables & connectors.  I am thinking 
cable/connector issues in the RF path. It's possible the issues are not even 
located very near the tuner.

A puzzler for sure.

GL 73
dan
k0dan

-----Original Message----- 
From: Tom Osborne
Sent: January 01, 2015 22:00
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Tuner SWR won't stay down

Hi Bob

No, it matches the antenna just fine.  SWR goes to zero.  Then it starts
to creep up after a few seconds.  Then I can re-tune it back to zero
again, but doesn't stay there.  Thanks and 73
Tom


On 1/1/2015 12:30 PM, W3YY wrote:
> The other tuner worked and your new MFJ didn't.  Sounds like whatever you
> are trying to match is outside the range of the MFJ, but OK with the other
> tuner you put in line.  Without further data, that's my initial 
> impression.
> GL.
>
> 73, Bob - W3YY

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk