[TowerTalk] 4 square

[Jeff AC0C]

Rex,

Ask around in your club.  Within the CADXA you have some very knowledgeable 
guys there.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message----- 
From: john at kk9a.com
Sent: Wednesday, July 22, 2015 7:49 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] 4 square

Typically the antennas are 1/4 WL apart (246/MHz=Ft) in a square.  There is
a plethora of information in the ON4UN Low Band DXing book and probably also
in the ARRL Antenna book.  If you are using a commercial controller it will
likely also have some layout instructions.

John KK9A


To: Towertalk Reflector <towertalk at contesting.com>
Subject: [TowerTalk] 4 square
From: Rex Turvin via TowerTalk <towertalk at contesting.com>
Reply-to: Rex Turvin <turvin2009 at yahoo.com>
Date: Wed, 22 Jul 2015 22:54:56 +0000 (UTC)

I am getting ready to build my 1st 4 square. Can someone direct to to a good

source of information that will help me in the correct placement of the
individual verticals? Also i am wanting to use raised radials.Any help is
appreciated.Thank you in advance73 NR6M
ex: KF7NMD

Sincerely,

Rex Turvin
Vice President CADXA
www.nr6m.com

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk