[TowerTalk] LMR-600: Crimp or Clamp Connectors?
Richard Thorne
rthorne at rthorne.net
Thu Jun 4 12:58:24 EDT 2015
John,
You definitely need a more flexible coax for rotor loops. I'll either
use a short length of RG-213, but more than likely will track down some
LMR-600uf which is the flexible version.
Rich - N5ZC
On 6/4/2015 8:19 AM, john at kk9a.com wrote:
> I am not familiar with this cable, can it run directly to the antenna or
> do you need a different cable for the rotator loop?
>
> John KK9A
>
>
> To: Towertalk <towertalk at contesting.com>
> Subject: [TowerTalk] LMR-600: Crimp or Clamp Connectors?
> From: Richard Thorne <rthorne at rthorne.net>
> Date: Thu, 04 Jun 2015 06:28:41 -0500
>
>
> I'm going to replace all of the RG213 coax on my current tower with
> LMR-600. I've been researching connectors.
>
> Looks like there are two varieties, crimp and clamp connectors. After
> watching a few you tube videos of the installation process of both, I'm
> leaning towards the crimp type. It does require a good crimp tool, but it
> looks a little more robust than the clamp variety.
>
> Any opinions out there if one is better than the other?
>
> Thanks
>
> Rich - N5ZC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
More information about the TowerTalk
mailing list