[TowerTalk] Looking for a Fulton winch

[Mike Reublin NF4L]

I forgot to say, I use a 24V wheelchair motor to drive the winches. It's variable speed, so it's easy to avoid heating the bushings.

73, Mike NF4L


> On Jun 11, 2015, at 4:34 PM, Mike Reublin NF4L <nf4l at comcast.net> wrote:
> 
> I used one for my raising fixture and to extend the tower and it didn't last long. Best I can figure, the bushing for the worm shaft siezed and turned in the frame. That cut the bushing and enlarged the hole. The thrust washers in front were pressed to paper thiness.
> 
> Fulton would not sell the parts (either to me or to a Fulton dealer) to fix it, nor reccommend a repair facility. I was able to get parts from several vendors and repair it. I used a LocTite product to glue the new bushing in. It's been flawless since then.
> 
> If I have to replace it I'd buy a Dayton SKU 12U381 from Grainger. $250.00. It appears to be identical, except it's painted red instead of black. They say there's no problem getting parts.
> 
> 73, Mike NF4L
> 
> 
>> On Jun 11, 2015, at 3:48 PM, Roger (K8RI) on TT <K8RI-on-TowerTalk at tm.net> wrote:
>> 
>> I know this has been on here several times, but I'm looking for a good source of tower winches for the raising fixture.  The book shows a worm gear drive, but what's on there is an inexpensive boat winch.
>> 
>> I'm thinking of ordering a Fulton worm gear drive, hand powered winch with about a 50:1 ratio.
>> Suggestions?
>> 
>> -- 
>> 
>> 73
>> 
>> Roger (K8RI)
>> 
>> 
>> ---
>> This email has been checked for viruses by Avast antivirus software.
>> https://www.avast.com/antivirus
>> 
>> 
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>