[TowerTalk] Rohn towers

[Jon Pearl - W4ABC]

Orlando is right around the corner from you...

http://www.alro.com/locations/locationsmain.aspx?Loc=FL





73,


Jon Pearl - W4ABC
www.w4abc.com



On 5/10/2015 1:30 PM, Bry Carling wrote:
> Thank you everyone. It sounds like I will just need to go with a much longer mast.
>
> Best regards - Brian Carling
> AF4K Crystals Co.
> 117 Sterling Pine St.
> Sanford, FL 32773
>
> Tel: +USA 321-262-5471
>
>
>
>
>> On May 10, 2015, at 11:29 AM, greenacres113 at charter.net wrote:
>>
>>
>>
>>     The 4 Rohn 25 towers I have up I mounted the rotor plale in the area
>> between sections. Between the top section & the next one from the top.
>> A lot depends on the rotor plate. Some generic plates have the U bolts
>> welded on & that's the only way to mount them. It's easier if you can
>> to mount the rotor plate in that joint area & put a Ham series on the
>> plate before putting the top section on. It turns freely in that area.
>> On my R45 the Tailtwister has lots of turning room. My R45 has a
>> thrust bearing on top. It was easier to mount the rotor mid top
>> section then lower the mast thru the thrust bearing into the rotor. We
>> used a manlift which made it simple.
>>
>>     K9IL
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com