[TowerTalk] Rohn towers

Roger (K8RI) on TT K8RI-on-TowerTalk at tm.net
Sun May 10 20:10:41 EDT 2015


On 5/10/2015 2:54 PM, Jon Pearl - W4ABC wrote:
> Orlando is right around the corner from you...
>
> http://www.alro.com/locations/locationsmain.aspx?Loc=FL
>
>
Standard disclaimer:  I have no interest in Alro other than being a 
satisfied customer

I didn't realize they were so wide spread, but Alro has an outlet about 
20 miles from me up here in Michigan.Their prices, up here are better 
than the local supply.  Although I may purchase 10 stock lengths of 1.5" 
and 2" diameter 6061T6 and DOM steel tube, at times I have called over 
with a relatively small order that I had planned on picking up.  They 
delivered it right to my door.  A small order is not just one piece of 
mast.  I assume they must have had another, larger delivery in the area.

As with large companies with multiple outlets, I assume policies may 
vary between outlets.

73

Roger (K8RI)

>
>
>
> 73,
>
>
> Jon Pearl - W4ABC
> www.w4abc.com
>
>
>
> On 5/10/2015 1:30 PM, Bry Carling wrote:
>> Thank you everyone. It sounds like I will just need to go with a much 
>> longer mast.
>>
>> Best regards - Brian Carling
>> AF4K Crystals Co.
>> 117 Sterling Pine St.
>> Sanford, FL 32773
>>
>> Tel: +USA 321-262-5471
>>
>>
>>
>>
>>> On May 10, 2015, at 11:29 AM, greenacres113 at charter.net wrote:
>>>
>>>
>>>
>>>     The 4 Rohn 25 towers I have up I mounted the rotor plale in the 
>>> area
>>> between sections. Between the top section & the next one from the top.
>>> A lot depends on the rotor plate. Some generic plates have the U bolts
>>> welded on & that's the only way to mount them. It's easier if you can
>>> to mount the rotor plate in that joint area & put a Ham series on the
>>> plate before putting the top section on. It turns freely in that area.
>>> On my R45 the Tailtwister has lots of turning room. My R45 has a
>>> thrust bearing on top. It was easier to mount the rotor mid top
>>> section then lower the mast thru the thrust bearing into the rotor. We
>>> used a manlift which made it simple.
>>>
>>>     K9IL
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


-- 

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com




More information about the TowerTalk mailing list