[TowerTalk] 2 inch Chrome Moly mast needed

[W2GR at aol.com]

Huh?...Really?
 
The set up on that would be a bear!..
 
A plasma cutter and a bit of layout you'd be done before you could set the  
mill head....just sayin'.
 
73
 
Mike W2GR
----------------
 
 
In a message dated 4/8/2016 7:06:29 P.M. Eastern Daylight Time,  
K8RI-on-TowerTalk at tm.net writes:

I could  rotate the head on the milling machine and bore out the opening 
in the  tower top plate to take a 3" mast and bearings, but at this 
point, it's  hardly worth the effort.

73

Roger   (K8RI