[TowerTalk] Which Thrust Bearing to Use

[K6UJ Bob Harmon]

Looks really well made.  I had the original Rohn counterpart for years and
it just kept on going.
I added a zerk fitting so I could grease it.  They last a very long time
dry without lube, but I am anal
about lubing everything hihi.


Bob
K6UJ

On Wed, Dec 7, 2016 at 5:17 PM, Tim Duffy <k3lr at k3lr.com> wrote:

> Here is an interesting thrust bearing video from DXE
>
> https://www.youtube.com/watch?v=EuewFM15Py4
>
> 73
> Tim K3LR
>
> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Bob
> K6UJ
> Sent: Wednesday, December 07, 2016 8:06 PM
> To: TowerTalk at contesting.com
> Subject: [TowerTalk] Which Thrust Bearing to Use
>
> I sent another supplier for a thrust bearing but it didn't attach to my
> message.Here it is again.  They have SS bearings if you like and also have
> 3"
> http://www.bearingson.com/category/4-bolt_flanges/cast_
> iron_4-bolt_flanges/u
> cf_series/2_4-bolt_flange_bearings_ucf_210-32.asp?page=2&SortType=0
>
>
> Bob,K6UJ
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>