[TowerTalk] Yaesu G-1000SDX Controller Problem

[KE4S-Dave]

While installing a LED illuminator board in my G-1000SDX controller, one 
wire on the indicator motor controller board separated from the other 
end.  This is the first one of the pair of gray wires attached to the 
motor controller board at the top right corner (viewed from the rear of 
the controller unit and marked "10" on the circuit board).  It crosses 
the back of the motor control board then wrap toward the face plate; 
this is the loose end.

Can someone who owns one of these units could open the controller and 
tell me where this wire should connect?  I have neither an owners manual 
or a schematic diagram.  A copy of either would also be appreciated.  
Note this is the SDX unit, which is considerably different than the DXA 
unit.

Thanks es 73,

Dave KE4S