[TowerTalk] Routing Coax and Control Lines

[Roger (K8RI) on TT]

You didn't state the mass and construction of the UFER ground.
Typically, more than one ground rod per leg is used unless the UFER is 
quite large.
It's quite difficult to get the bottom coax grounding, at, or below 
grade.  Moisture, soil, water, and/or, snow may dictate the necessity of 
mounting said grounding somewhat above grade.  My bottom grounds are 
about 6" above grade which often puts them as much as 2' below the 
surface of the snow.

Because there is so little loss at HF, I prefer to use thoroughly 
weatherproofed bulkhead connectors for grounding the shields. Each one 
adds up, but even with as many as 10 connectors, the loss is still 
minuscule.

73

Roger (K8RI)


On 7/9/2016 Saturday 7:44 PM, Ken Mitchell via TowerTalk wrote:



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus