[TowerTalk] Biggest rotor that will fit in a Rohn 25G

[Danny Pease]

John, N9JF used a 6 foot long piece of 6 X 6 X 1/2 inch galvanized angle
iron fastened across the tower about 4 feet down from the top. He uses 4
guys wires, two on each end of the angle iron. This is not quite as
effective as a star guying system, but an improvement over the usual Rohn
torque arms.

Danny NG9R


Message: 2
Date: Thu, 21 Jul 2016 11:50:32 -0400
From: "john at kk9a.com" <john at kk9a.com>
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Biggest rotor that will fit in a Rohn 25G
Message-ID: <2438b61f57f5752fc4cd4a275ffd4032.squirrel at www11.qth.com>
Content-Type: text/plain;charset=iso-8859-1

Does N9JF use a 6 guy cable torque stabilizer or just three torque arms
attached to the tower. The latter does little to prevent twisting.  A Green
Heron controller sounds like it would be a nice addition to the AlfaSpid.

John KK9A