[TowerTalk] Loosening Al tubing to Al Tubing

StellarCAT rxdesign at ssvecnet.com
Sun Jun 12 18:19:39 EDT 2016


THAT was the stuff - PB Blaster... let it sit for DAYS ... nothing - nada.

Tried WD-40 just for SnG's, and yes I'm aware its water displacement but it 
also does work in some lubrication cases - works great on silencing a 
squeaky hinge!

g.



-----Original Message----- 
From: Roger (K8RI) on TT
Sent: Sunday, June 12, 2016 12:48 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Loosening Al tubing to Al Tubing

There are much better penetrants than WD40. The WD stands for water
displacement.  HOWEVER with Al to Al, in small engines with stuck
pistons, you take the spark plug out, dump in some liquid WD40 and "try
it the next day. Generally the motor will turn over easily.

The key in all of these approaches is the "wait"

Try PB Blaster, or Mouse Milk (yes that's a real name) and wait. You
need to give the penetrating oil tine to work. "Generally", it's not a
squirt and pull!

Forcing stuck, Al to Al is likely to cause galling where the Aluminum in
the tubes "joins" as if they were welded.

"Usually" old antenna tubing is stuck due to oxidation, or salt
corrosion. In that case heat "may" work, but it's a fine line between
not enough and too much. If it were me(and it's not), I'd give the end
of the outer tube a shot of PB Blaster, wait 24 hours and then try
"tapping the screwdriver in the end trick suggested in one of the first
couple of posts

73

Roger (K8RI)


On 6/12/2016 Sunday 8:29 AM, StellarCAT wrote:
> I have a few sections from a used yagi purchase that are like this - a few 
> of them I managed to get apart with lots of effort using a screw driver in 
> an existing hole and lots of pulling ... the rest just wouldn't budge. 
> Heating I don't believe works - its near impossible to heat them 
> independently - so they expand together... I tried WD-40, and the slippery 
> stuff - can't remember its name but for this purpose - nothing worked. 
> These pieces are now in my scrap pile replaced with new material from DXE.
>
> Gary
>
>
> -----Original Message----- From: Don W7WLL
> Sent: Saturday, June 11, 2016 7:31 PM
> To: Towertalk
> Subject: [TowerTalk] Loosening Al tubing to Al Tubing
>
> Want to restore a small inherited tribander for portable activity.
>
> Have a couple of tube to tube joints that are not coming apart with 
> ‘gentle persusian’. They been sitting in a coast air environment for a few 
> years (maybe 10).
>
> What recommendations here on TT of best solutions (s) to work into the 
> joints.
>
>
> Don W7WLL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


-- 

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus





More information about the TowerTalk mailing list