[TowerTalk] HamIV - T2X bolt holes

[KJ6Y at aol.com]

Bolt pattern is the same but the T2X uses 5/16" bolts and the Ham IV uses  
1/4".  T2X also has 6 bolts and is taller.
 
 

Skip,  KJ6Y
Communications Service Co
818-887-3569
_www.kj6y.com_ (http://www.kj6y.com/) 

 
 
 
In a message dated 6/29/2016 3:51:29 P.M. Pacific Daylight Time,  
ac9s at hotmail.com writes:

A friend  of mines' T2X went bad and I am going to lend him one of my 
HamIVs while he  gets it repaired.  Question - do the two rotators share a common 
bolt  pattern?  Can I tip the old rotator out and slip in the new one on 
the  same rotator plate.  When I installed his T2X a couple of years ago I  
left enough leeway in the mast to allow me to easily tip the rotator out, so  
if the bolt patterns are common enough I should be able to swap rotators in 
a  single climb.


Thanks -  Keith

AC9S
_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk