[TowerTalk] U.S. Tower Rotor Plate

[h.duck]

Good afternoon,

I have an older crank-up tower made by the predecessor to U.S. Tower.

The rotor plate for that tower sat on the horizontal cross braces and had a 
small lip that stuck down about 1/2 inch on the inside of the cross braces 
to hold the plate in place.

I just purchased a new rotor plate from U.S. Tower and it is different.  It 
fits inside the cross braces.  Also there are two small holes located at 
each corner.

Could someone who has a new U.S. Tower tell me how this is supposed to 
mount?

Thank you all very much.

Howard, WA9YBW 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus