[TowerTalk] Another conduit question

[Matthew Kaufman]

Electric code requires conduit assembly prior to running wire/cable for a
reason.


On Mon, Aug 28, 2017 at 1:29 PM William Carr <k5tu at att.net> wrote:

> I used this exact procedure and it worked well.  I had 4 runs of
> LMR-400-DB and one of 1/2 inch heliax in 4" conduit.
> Kim  K5TU
>
> Sent from Yahoo Mail on Android
>
>   On Mon, Aug 28, 2017 at 14:36, K7LXC--- via TowerTalk<
> towertalk at contesting.com> wrote:   >  How about laying out the cables in
> a bundle and then  slipping each ten
> foot abs piece over the end  of the cables and slide it  up to the
> previous
> abs piece and glue them together one at a time.  In that manner I would
> not have to Pull heavy  cable.  I would  have to watch the abs glue as it
> may
> melt the cable coverings.
>
>     Yes, you would. Had a customer who did that very  thing that resulted
> in that particular run of cable was there permanently with  no chance of
> swapping it out.
>
>     Be careful. Be VERY careful!
>
> Cheers,
> Steve    K7LXC
> TOWER TECH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>