[TowerTalk] Abrasion resistant wire antenna support suggestions

[Les Kalmus]

Hang a pulley over a limb and secure it. Run the antenna support line 
through the pulley. No more abrasion.

Les W2LK


On 2/15/2017 7:22 PM, NC3Z Gary wrote:
> I have been using what I thought was high quality UV resistant Dacron to
> support my inverted L's. But the problem is as it runs through the
> support pine trees it comes into contact with several limbs and branches
> and it has been abraded to the point of failure in about 6 months. This
> has happened a couple of times.
>
> Any good products out there that is more resistant to limb abrasion?
>
>
> Gary Mitchelson
> NC3Z/4 Pamlico County, NC FM15
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk