[TowerTalk] Saddle clamps (muffler clamps)

[Tim Duffy]

Hello John

You are correct.

73
Tim K3LR

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
john at kk9a.com
Sent: Sunday, July 02, 2017 12:21 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Saddle clamps (muffler clamps)

It appears that DX Engineering upgraded the u-bolts after buying the
product.  As I recall I could barely clamp a 5/16 plate to my Rohn 55 tower
and that was with no lock washer.

John KK9A


To:	towertalk <towertalk at contesting.com>
Subject:	Re: [TowerTalk] Saddle clamps (muffler clamps)
From:	Steve Maki <lists at oakcom.org>
Date:	Sat, 1 Jul 2017 17:46:48 -0400

The current 2" and 3" versions (with 3/8" u-bolts) have plenty of u-bolt
length - I suspect the other sizes do as well, but I've only got the 2's and
3's in front of me.

The 2" has 1.5" of bolt thread showing past the saddle when mounted on a 2"
OD tube. The 3" has 1.25" of thread showing when on a 3" OD tube.

-Steve K8LX

On 7/1/2017 13:44 PM, john at kk9a.com wrote:

I purchased some of these from K5GO/N5DX for a temporary project. The
pricing was great and so was their customer service! I am not sure if the
design has changed since DX Engineering took over however the issue that I
had was I had to use a much thinner plate then I had planned because of the
short bolt length.

John KK9A

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk