[TowerTalk] Fwd: MA40 and T2X rotor off center

[Julio Peralta]

I believe the maximum mast size a TX2 rotor will accept is 2 1/16" not 2 1/8".

Julio, W4HY

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of FERNANDO MUGUERZA VIDEGARAY
Sent: Sunday, December 16, 2018 1:07 AM
To: towertalk at contesting.com
Subject: [TowerTalk] Fwd: MA40 and T2X rotor off center

I checked in one spec of the T2X rotor and says can drive pipes up to 2-1/8”, so the shims should be 1/16” each for a 2” pipe.
Also check if rotor base is centered on the tower’s base.
   Fernando,XE2FL

Fernando José Muguerza,XE2FL
Cel. 81.1589.2930
Email. Fernandojmuguerza at gmail.com
Email. xe2fl.kf5mn at gmail.com

Enviado desde mi iPhone

Inicio del mensaje reenviado:

> De: FERNANDO MUGUERZA VIDEGARAY <xe2fl.kf5mn at gmail.com>
> Fecha: 15 de diciembre de 2018, 23:46:45 GMT-6
> Para: towertalk-owner at contesting.com
> Asunto: MA40 and T2X rotor off center
> 
>  I think the reason for the wooble of the rotor output is because the rotor is capable of turning Antenna’s pipes up to a list 2-3/8” in diameter,if one uses 2” pipes,since one of the grips is fixed with the base of the rotor and the other is movable to clamp,the shaft will be off center,unless you shim(3/16”) both sides to make to be centered in this case!
>        Fernando,XE2FL
> 
> 
> Fernando José Muguerza,XE2FL
> Cel. 81.1589.2930
> Email. Fernandojmuguerza at gmail.com
> Email. xe2fl.kf5mn at gmail.com
> 
> Enviado desde mi iPhone
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk