[TowerTalk] TowerTalk Digest, Vol 196, Issue 26

[Jim Brown]

The editing commands you need are on the Wire Tab of the Wires table in 
EZNEC by W7EL.  The copy and rotate function is under Make Multiple Copies.

The project that you're attempting is non-trivial, so a study of the 
manual for the NEC version you're using is in order. Those of us who 
know enough to answer questions have already done that.

73, Jim K9YC

On 4/24/2019 10:37 PM, Greg Best via TowerTalk wrote:
> Thanks to you all for your questions, thoughts, and input.  My original question was about interaction with the tower and really asking the question as to whether someone besides me has addressed the issue before. (Better to take advantage of work done before rather than recreate the wheel.). For your further consideration, the tower face at 60 ft is about 30” and it is 3 sided. The mount would likely be fixed on EU or a small robust  sidearm with “rotator on a post” realizing that I would not be able to turn it fully around. All of the bracing is  “X”
> braces using 1.5” angle steel above and below the 60 ft level.  The spacing between the DE & D1 is 106” so i do have some room. The balance point is abt 63” from the DE. The 20 m beam is a Wilson 204CD. I am not familiar with the NEC command to “mirror “ the wires. Is it “copy” or something else?