[TowerTalk] Lift Mast to Replace Rotator

[Doug Turnbull]

John, Use a lever (large screwdriver) to lift the mast a quarter to half
inch.   Then clamp the mast above head unit with either a muffler clamp,
large hose clamp or perhaps a locking bolt in the Head Unit if you are
fortunate.

                73 Doug EI2CN

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of John
Sloop
Sent: 26 December 2019 22:02
To: TowerTalk at contesting.com
Subject: [TowerTalk] Lift Mast to Replace Rotator

I'm looking for suggestions to lift mast, with antennas just enough to
replace the rotator, which is a Ham III.  Rotator is shelf mounted about 2
feet below the top thrust bearing.  All ideas are appreciated.

 

John S.

AA0ES

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk