[TowerTalk] Lift Mast to Replace Rotator
W3YY
w3yy at cox.net
Thu Dec 26 19:46:22 EST 2019
John -
Next time install two bearings that provide both lateral and thrust support.
And then install the mast so there is no weight on the rotor. Then you can
easily remove and replace the rotor.
73, Bob - W3YY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of John
Sloop
Sent: Thursday, December 26, 2019 5:02 PM
To: TowerTalk at contesting.com
Subject: [TowerTalk] Lift Mast to Replace Rotator
I'm looking for suggestions to lift mast, with antennas just enough to
replace the rotator, which is a Ham III. Rotator is shelf mounted about 2
feet below the top thrust bearing. All ideas are appreciated.
John S.
AA0ES
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list