[TowerTalk] Masting source

[Jeffrey Okamitsu]

Try onlinemetals.com

73. Jeff
W3KL

Sent from my iPhone

> On Dec 28, 2019, at 12:34 PM, K9MA <k9ma at sdellington.us> wrote:
> 
> Bob,
> 
> Are you putting the rotator in the tower with a thrust bearing or sleeve?
> 
> 73,
> Scott K9MA
> 
>> On 12/28/2019 10:39, Dave Hachadorian wrote:
>> I bought a 10-footer once from Texas Towers.  They cut 1 foot off to make it UPS shippable.  That was a long time ago though.
>> 
>> Dave Hachadorian, K6LL
>> Yuma, AZ
>> 
>> 
>> -----Original Message----- From: Rob Matherly
>> Sent: Saturday, December 28, 2019 9:26 AM
>> To: TowerTalk at contesting.com
>> Subject: [TowerTalk] Masting source
>> 
>> Hi All -
>> 
>> Could someone point me to a source for antenna mast? It needs to be strong
>> enough for my A4S and 10-element 2m beam. I was thinking 10' in height, is
>> that too much? I've not had an actual bell rotor atop a tower before.
>> Everything prior has been TV rotors on masts.
>> 
>> Thanks!
>> 
>> Rob Matherly, W0JRM
>> Centerville, Iowa - EN30nr
>> SKCC 29, FISTS 19246
>> 
>> "Aude, vide, tace, si vis vivere in pace."
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 
> -- 
> Scott  K9MA
> 
> k9ma at sdellington.us
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk