[TowerTalk] Yaesu rotator connectors
W4LDE
w4lde at numail.org
Thu Jul 25 08:38:59 EDT 2019
Grant,
A ham buddy about a hour from me has a problem with the standard rotor
plug being to big and when he cranks the tower down he is concerned that
the plug will hit the top frame of the lower section.
I suggest he look for a 90 deg plug but I'm not sure after reading your
post and looking at the Nanoboshi web site if there is a animal. Have
you seen a 90Deg Yaesu 2800 connector, I think that is his model number.
Later today I might give Advanced a call.
Thanks for any idea's or input you can provide.
73 de Ron W4LDE
On 7/25/2019 1:30 AM, Grant Saviers wrote:
> For the poster asking about Yaesu connector pins:
>
> The connectors for my Yaesu G-1000 are Nanoboshi
>
> NJC-207-PF 7 pin female plug fits the rotator (I have extras to make a
> short bench test cable)
>
> NJC-207-ADM 7 pin male adapter (if you want to make an extension cable)
>
> Last purchased 5/13 from Advanced Technology Products, 937 349 4055
>
> I replace the mystery keyed Molex on the back of the control with a
> Jones 6 pin.
>
> If you ever have to fix your Yaesu controller, trash it and buy a
> Green Heron.
>
> Grant KZ1W
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
More information about the TowerTalk
mailing list