[TowerTalk] Thrust Bearing for Use with Prop Pitch Rotor

[Tim Duffy]

Best bearing - can take lots of weight.

https://www.dxengineering.com/parts/dxe-tb-300

Very different from the Rohn 

73
Tim K3LR

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
Patrick
Sent: Sunday, March 10, 2019 12:20 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Thrust Bearing for Use with Prop Pitch Rotor

I'd double check the need for a down thrust bearing to relieve the 
weight from the PP unit. Kurt Andress the preeminent PP re-purpose guru 
advised me against it.

Patrick        NJ5G


On 3/10/2019 10:16 AM, Mike wrote:
> Hello,
>
> What have others used to take the weight off of a tower mounted prop pitch
> rotor?
>
> Presently, in the final stage of modifying a rescued prop pitch and,
> unfortunately,  it didn't have the triangle bearing plate.  Plan to use a
> couple of Rohn TB3 thrust bearings, one at top of the tower and the other
> approx. 2 ft below the top, but wanted to find out what others
successfully
> have used to keep the weight off prop pitch rotors.
>
> The load will consist of a 2" dia. X 1/4" wall X 21 ft chrome molly mast
> plus a homemade 40 m Moxon (approx. 70 lbs) and a 4 el SteppIR (approx. 50
> lbs).
>
> I've review the TT archive for thrust bearings for possible application
> with a prop pitch rotor without any consensus on what to use other than
the
> available thrust bearings are not reliable in the long run.
>
>    73,
>    Mike, K4GMH
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> ---
> This email has been checked for viruses by AVG.
> https://www.avg.com
>
>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk