[TowerTalk] Thrust Bearing for Use with Prop Pitch Rotor
Stan Stockton
wa5rtg at gmail.com
Mon Mar 11 15:27:42 EDT 2019
Similar to what W7RY recommended but 2-1/8". Last time I bought any they were 2-1/8" because of too tight fit on 2".
https://www.thebigbearingstore.com/2-1-8-four-bolt-flange-bearing-w-lock-collar-hcfs211-34/
73... Stan, K5GO
On Mar 11, 2019, at 7:54 AM, Paul Christensen <w9ac at arrl.net> wrote:
>> So, many of this type of bearing will not work due to the tight tolerances. A mast that’s been galvanized usually will not fit. 73 de Steve, NR4M
>
> Good point, Steve. Two years ago, N4CC and I were 48 hours away from "crane day" when we tested the fit of a 3-inch galvanized chromoly mast into a 3" flange bearing. The mast was approximately 1/16" wider than the ID of the bearing. We placed an emergency order through DXE for a set of Rohn TB-4 bearings which has the necessary clearance.
>
> The TB-4 raceway design is terrible but they've been working fine for the last 24 months. Had the DXE bearings been available, we would have chosen that design over the TB-4.
>
> Paul, W9AC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list