[TowerTalk] RG-213 Hi Pot ?
Mac
libbysales at austin.rr.com
Fri May 10 13:04:32 EDT 2019
I'm wrong it seems [again] it is used in 10kw applications i have here
.. but the specs sure dont support that from what i just reviewed.. im
moving pretty fast as i am on a real project and might well be
overlooking many parts of this .. i will try later when i have more
time .. mac/mc w5mc
On 5/10/2019 11:55 AM, Steven Katz wrote:
> The mil spec rating for RG-213/U is 3700Vrms max; this is 5232Vpk.
>
> I wouldn't use it at 7.7kVdc.
>
> -----Original Message-----
> From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Jim Thomson
> Sent: Friday, May 10, 2019 9:52 AM
> To: towertalk at contesting.com
> Subject: [TowerTalk] RG-213 Hi Pot ?
>
> Does anybody know how much max V is on RG-213 ? Like what are the results if a hi-pot tester used..
> and say cranked up to the point where just a few ma occurs . I have an application where I need a HV
> cable, less than 10 ft, that will easily handle 5700 / 7700 vdc. It will be hardwired at both ends, no HV connectors.
> And with braid peeled way back from the center conductor, like 2-4 inches .
> The plan was to also wrap some red electrical tape every few inches along its entire length, to readily identify it as a HV cable.
>
> Tnx.... JIm VE7RF
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
More information about the TowerTalk
mailing list